High accuracy, high sensitivity
Mottech Submersible Water Level Sensor
Mottech Submersible Water Level Sensor is with stainless steel isolation diaphragm diffusion silicon pressure core body,
the pressure core body adopts the process of laser trimming resistor for a wide temperature range of zero and sensitivity temperature compensation.
Special cable for air-venting conduit and waterproof technology ensures water tightness, and ventilation between inside and outside, so as to acquire accurate and stable measuring data.
The Mottech Submersible Water Level Sensor can be connected directly to any controller in Mottech’s system via Analog input or Mottech Smart Card.
Top Features
-
01
-
02
Fast response
-
03
Good stability
-
04
Strong resistance to interference
-
05
Strong resistance to interference
-
06
Anti-corrosion material optional
-
07
Low temperature drift
-
08
Wide Temperature Range Compensation
Technical Specficiations
Range
Standard: 0-10m, optional: 0~0.5…200m H2O or 0 ~ 5KPa…2MPa
Output
4-20mA, 0-5V, 0-10V, RS485
Supply Voltage
10-30VDC, 24V typ.
Over Pressure
2×FS
Measuring Medium
The liquid(not sticky ) compatible with 316 stainless steel
Total Accuracy
0.1%FS, 0.3%FS(0.25%FS), 0.5%FS
Long-term Stability
0.1%FS/year typ., 0.2%FS/year max.
Ingress Protection
IP68
Operating Temperature
-40°C~ +80°C
Compensating Temperature
-10°C~ 70°C
Temperature Drifting
0.03%FS/°C typ., 0.05%FS/°C
Cycle Life
1*10^8 @25°C
Main Material
Sensor: 316L, housing: 304SS(316L is optional)
Cable
Outer material: PUR, Atmospheric pressure compensation cable, Polymer waterproof plug at cable end
Cable Length
Standard cable length: 20m. Can be ordered in other lengths
Power Consumption
Current output: (U*0.02)W, Voltage output: (U*0.008)W, Digital output: (U*0.015)W
Load Capacity
Current output:≤(U-7)/0.02Ω, Voltage output:≥100kΩ
Weight(probe unpacked)
Approx. 230g
Storage Condition
10°C-50°C@20%-90%RH
Code
M.SENS-71-A
Dimensions
Unit: mm
The default diameter is 27 mm.
19 mm or 13 mm external diameter is customizable.
Mounting
- As shown in picture 1, when the sensor is installed in static water such as in pools, water towers, probe is immersed into the bottom and should be as far as possible away from the pump or valves.
The terminal box should keep above water surface and prevent water penetrating into cables.
Please make sure the airway not be blocked. - As shown in picture 2, when the sensor is installed in dynamic water such as dams or rivers, probe should be inserted into a steel pipe (inner diameter is around 45mm), burrowing several holes at different height on the pipe side wall which is opposite to the water flow direction. The terminal box should keep above water surface and prevent water penetrating into cables. Please make sure the airway not be blocked.
Contact Mottech
Mottech Water Solutions Ltd.
Mottech USA Inc. 9810 Liberty Road Aubrey, TX 76227
amir@mottech.com
Mobile: +972- 54-597-0428
Tel. +972-(0)9-9616000
